WM3000 Controller - Resetting Controller to Factory Default Values

1. boot connected to serial port
2. keep pressing esc as the system boots up

   BootOS 4.2.1.0-008R (r75044)
   Base MAC Address = 00:04:96:42:14:79
   Management MAC Address = 00:04:96:42:14:84
   Board Serial Number = 0943L-00012
   PS2606 version 1, product type 2, generation 1, model 3, manuf 1059
   FPGA firmware revision 1.23
   MIPS ProcessorID 0.12.6.4
   XLR CPU_ID 0x6: 2 MIPS cores at 1.00GHz, 2x256KB L2 cache, 1+1 security coprocessors
   NOR bootstrap version 8, checksum good
   boot>

3. when you get the boot prompt enter the set factory_defaults command followed by the reset command.

   boot> set factory_defaults
   
   This operation restores the switch to the same state as it was in when originally shipped from the factory. All configurations, licenses, dumps, keys, etc. will be deleted. Continue [y/n]:y
   
   boot> reset